You can enable maintenance mode on the
SLX devices that XCO manages.
About this task
By default, XCO performs Drift and Reconcile
actions on the SLX devices that enter into maintenance mode after reboot, taking those
devices out of maintenance mode after successfully reconciling the configuration on
them. For more information about Drift and Reconcile, see Drift and Reconcile.You can enable
maintenance mode on SLX devices without triggering Drift and Reconcile. Take the
following steps.
Procedure
-
Disable syslog.
efa inventory device execute-cli --ip 10.18.120.187 --command "no logging syslog-server 10.18.120.140 use-vrf mgmt-vrf" --config
-
Enable maintenance mode.
efa inventory device setting update --maint-mode-enable Yes --ip 10.18.120.187
The device remains in maintenance
mode until you disable the mode.
If both maint-mode-enable and maintenance-mode-enable-on-reboot are set on the device,
the Drift and Reconcile action is not triggered on device
reboot.
-
Disable maintenance mode.
-
Enable syslog.
efa inventory device execute-cli --ip 10.18.120.187 --command "logging syslog-server 10.18.120.140 use-vrf mgmt-vrf" -–config
-
Run Drift and Reconcile.
efa inventory drift-reconcile execute --ip 10.18.120.187 –reconcile
The Drift and Reconcile process takes the device out of
maintenance mode.
